Kobra Cyclone - Page 15

15 of 30 DI-129/11/07.07.15
USA
ELECTRICAL INSTALLATION AND WIRING
IMPORTANT!!!
After the Cyclone has been connected to the power supply it is necessary to check
the auto-shut off time by adjusting the “ALARM C” knob as shown in the “Electrical
Set-up and Tuning” section at the end of this operating instruction book.
The adjustment of the “ALARM C” knob will adjust the automatic shut-down time of
the Cyclone based on the local power.
The “ALARM C” knob is already set at the factory but small differences in the local
power requires the adjustment of the shut down time at the installation location.