4
Trouble Shooting
Trouble Shooting
Summary
1 Algae...............................................................................................................5
1.1 Excessive algae growth in water tank......................................................5
2 General ...........................................................................................................5
2.1 Machine has no power.............................................................................5
3 Drive................................................................................................................5
3.1 Filmfeed out of order, dryer-fan is working ..............................................5
3.2 Machine does not start automatically ......................................................5
3.3 Machine doesn't stop automatically.........................................................5
3.4 Drive motor does not run .........................................................................5
3.5 Transport stops before film comes out, changing the cycle time.............6
3.6 Processing time and developer temperature relation ..............................6
3.7 Changing the transport speed .................................................................6
4 Developer Bath ...............................................................................................7
4.1 No circulation in bath ...............................................................................7
4.2 Developer temperature too high..............................................................7
4.3 Developer temperature too low................................................................8
4.4 Developer temperature too low, fixer temperature too high.....................8
4.5 Removing the turning knob......................................................................8
4.6 Calibration of developer temperature ......................................................8
5 Film defects.....................................................................................................8
5.1 Films will not dry......................................................................................8
5.2 The film does not transport correctly .......................................................8
5.3 Scratches, pressure marks, dirt on film ...................................................8
6 Replenishment................................................................................................9
6.1 Replenishment pump does not pump or not sufficiently..........................9
6.2 Replenishment rates are too high or too low...........................................9
6.3 Adjust replenishment pump .....................................................................9
7 Dryer ...............................................................................................................9
7.1 Dryer fan does not function or runs with reduced speed .........................9
8 Water...............................................................................................................9
8.1 Rinsing water does not flow.....................................................................9
8.2 Water tank overflows ...............................................................................9
The main components (circuit board, pumps, motors) of the
processor are located underneath the tanks. To perform ser-
vice you must drain the tanks, remove all racks, turn proces-
sor on side and remove bottom panel.
To Next Page
Loading...
Need help?
General
