Need help?Do you have a question about the Kodak 104 and is the answer not in the manual?
General| Type | Laser Imager |
|---|---|
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Film Sizes | 8x10, 10x12, 11x14, 14x14, 14x17 inches |
| Film Types | Dry Laser Film |
| Connectivity | Ethernet |
| Compatibility | DICOM |
| Technology | Dry Laser |
Details electrical socket specifications including voltage, amperage, and safety switch requirements.
Specifies requirements for filtered fresh water connection, including pressure and temperature.
Outlines specifications for plastic drainage pipes and containers for used developer and fixer.
Provides guidance on storing replenishment tanks and required darkroom ventilation rates.
Details minimum inner dimensions for the sink with freshwater and flexible hose.
Addresses problems caused by algae growth in the water tank and potential overflows.
Covers common issues such as lack of power or automatic start/stop malfunctions.
Details troubleshooting steps for drive motor issues, transport stops, and speed adjustments.
Guides on resolving issues with developer circulation, temperature control, and calibration.
Explains causes and solutions for films not drying, transport errors, scratches, and dirt.
Addresses problems with replenishment pump operation, rates, and adjustments.
Troubleshoots issues related to the dryer fan not functioning or running at reduced speed.
Covers problems with rinsing water flow and water tank overflows.
Lists spare parts for the main unit, including pumps, switches, and circuit boards.
Details spare parts for the drive system, such as motors, gears, and shafts.
Lists spare parts for ancillary systems like air channels, heating, valves, and sensors.
Illustrates and lists mechanical parts including rollers, guide bars, springs, and bearings.
Provides a detailed list of mechanical components like side plates, gears, and rollers.
Details the contents and quantities of the Large Spare Parts Kit.
Details the contents and quantities of the Small Spare Parts Kit.
Presents the overall wiring schematic for the processor, showing connections to major components.
Illustrates the physical layout and component placement on the control electronics board.
Provides detailed circuit diagrams for specific sections of the control board, including power and relays.
Details wiring for microcontroller, sensors, display, and rotary switches.
To Next Page
