Kodak 2200 - User Manual

Questions and Answers

F
fred65Aug 1, 2025
What to do if x-ray emission works, but exposure is too dark on Kodak Medical Equipment?
- R
  Robert RodriguezAug 1, 2025
  If the x-ray emission works, but the exposure is too dark, consider the following potential causes and solutions: * The wrong exposure pre-set program is being used. Change the pre-set program. * The exposure time is too long. Decrease the exposure time. * The development time is too long. Decrease the development time. * The developer is too hot. Cool the developer. * The developer is too concentrated. Adjust the concentration or replace the developer. * The pre-set mode is incorrectly selected. Verify your exposure settings.
C
craiggoodmanAug 7, 2025
Why nothing lights up on my Kodak 2200 Medical Equipment?
- J
  Jennifer ScottAug 8, 2025
  If nothing lights up on your Kodak Medical Equipment, it could be due to a few reasons: * The unit might be disconnected. Connect the unit. * Fuse F1 might be burned out or defective. Replace the fuse. * The circuit breaker might be off. Turn on the circuit breaker.
J
Jennifer CampbellAug 13, 2025
What to do if control unit doesn’t light up on Kodak 2200?
- B
  Bradley BradleyAug 13, 2025
  If the control unit doesn’t light up on your Kodak Medical Equipment, it could be due to several reasons: * The control unit might be disconnected. Connect the control unit. * Fuse F1 might be burned out or defective. Replace the fuse. * The control unit might be defective. Call a qualified service technician.
E
Eric BensonAug 19, 2025
Why is there no x-ray emission from my Kodak 2200 Medical Equipment?
- O
  onolanSep 12, 2025
  If there is no x-ray emission from your Kodak Medical Equipment, it could be because: * The generator is cooling. Wait for the I 01 message and the red LED on the control unit to disappear. * The radiology control key is defective. Call a qualified service technician.
C
Cynthia CookOct 25, 2025
What to do if x-ray emission works, but exposure is too light on Kodak Medical Equipment?
- C
  carla31Oct 25, 2025
  If the x-ray emission works, but the exposure is too light or completely white, consider the following potential causes and solutions: * The wrong exposure pre-set program might be in use. Try changing the pre-set program. * The generator might be positioned incorrectly. Adjust the position of the generator. * The exposure time might be too short. Increase the exposure time. * The development time might be too short. Increase the development time. * The developer might be too cold. Heat the developer. * The developer might be too old or diluted. Replace it with fresh developer. * The pre-set mode might be incorrectly selected. Verify your exposure settings. * The receptor might be facing the wrong way. Reposition the receptor. * The unit was incorrectly installed. Call a...