Kodak 305 - Repairing a Torn Ribbon; Torn Ribbon Repair Method

March 2018 4-1
4 Trou ble shoot ing
Printer Error Messages
The printer driver uses the standard error handling provided by
the operating system. Error messages are displayed with the
spooler status window (printer queue).
NOTE: When an error occurs during printing, it may appear on
the monitor. Check the operator control panel for
additional information.
Number
Problem/Error Message Description or Causes Solution
1 The printer is not
connected.
The printer driver cannot
connect to the printer.
Check that the printer power is on
and that the printer is connected to
your computer.
2 The printer does not
respond.
----
• Click OK.
Turn the printer off and then back
on.
• If problem persists, contact
KODAK Service and Support.
3 Something is wrong with
the printer. (XXXXXX).
----
• Click Cancel.
Turn the printer off and then back
on.
• If problem persists, contact
KODAK Service and Support.
4Mechanical
Error(XXXXXX).
Set paper again.
• Out of paper
• Paper is partially
loaded
• Paper ran out while
loading
Load paper or check that the paper
is installed properly.
5Mechanical
Error(XXXXXX).
----
• Click Cancel.
Turn the printer off and then back
on.
• If problem persists, contact
KODAK Service and Support.
6 Printing unit is opened. The print unit is opened. Check the operator control panel
for additional information and close
the print unit.
7 Printing unit is opened
while printing.
The print unit is opened. Check the operator control panel
for additional information and close
the print unit.