Doing more with your camera
www.kodak.com/go/support
38
Changing PASM or C1, C2, C3 mode settings
PASM and C modes control the f-number (aperture), shutter speed, exposure
compensation, and flash compensation.
1 Turn the Mode dial to P, A, S, M, or C1, C2, C3.
2 Use the Command dial and Set button:
■ Turn the Command dial to move the selection
arrow between the available settings.
NOTE: For C1, C2, or C3, choose custom
exposure setting (PASM) in the Menu,
see page 50.
■ Press the Set button to open a setting.
■ Turn the Command dial to adjust the setting,
then press Set to close.
3 Press the Menu button to change other settings
(see page 42).
4 Take a picture.
Using exposure compensation with exposure bracketing
In PASM modes, you can use exposure compensation in conjunction with exposure
bracketing.
PASM & C mode options
White—selectable
Blue—non-selectable
Yellow—changeable value
Red—out-of-range
If the exposure
compensation is
set to:
And if the exposure bracketing
interval is set to 3 steps:
Then the exposures
taken are:
0.0
+1.0
–1.0
Set the drive mode to Exposure
bracketing 3 (see page 30)
–0.3, 0.0, +0.3
+0.7, +1.0, +1.3
–1.3, –1.0, –0.7
Downloaded from ManualsCamera.com Manuals
To Next Page
Loading...
