Kodak HERO 4.2 - Entering Fax Sender Information

Faxing
90 www.kodak.com/go/aiosupport
If you have an answering service:
If you have an answering service that uses a computerized system for recording
messages remotely for the same phone line that you use for your all-in-one
printer, then you can set up a distinctive ring to receive faxes automatically (see
Distinctive Ring in the table under Selecting fax settings, page 91).
If you do not set up a distinctive ring, you can still receive faxes manually (see
Receiving a fax manually, page 100).
Entering fax sender information
Fax sender information appears in the header of any fax that you send from your
all-in-one printer. Typically this is your name or your business name and your fax
number.
NOTE: If you do not enter fax sender information, the header on faxes that you send
will be blank.
To enter fax sender information:
1. Press .
2. Touch , then touch
Fax.
3. Touch
Fax Settings, touch Fax Sender Information, then touch a field to enter:
• your name or business name
•your fax number
4. Press OK to save the information.