Kodak i4250 - Scanning Operations

A-61837 June 2015 3-1
3Scanning
Contents Getting your scanner ready to scan ...........................................................3-1
Adjusting the input elevator....................................................................3-2
Installing the document extender ...........................................................3-4
Adjusting the output tray or rear edge alignment or improved or best
document handling.................................................................................3-4
Adjusting the output tray for lead edge alignment and normal document
handling..................................................................................................3-6
Using the rear document exit .................................................................3-6
Getting your documents ready to scan ......................................................3-7
Scanning documents..................................................................................3-8
Starting, stopping and pausing the scanner ...........................................3-8
Quick clean using the Start/Pause button ..............................................3-8
Using the Operator Control Panel..............................................................3-9
Ready screen.......................................................................................3-10
Status area........................................................................................3-10
Displaying the Operator Log.............................................................3-12
Displaying scanner Information ........................................................3-12
Diagnostics .......................................................................................3-13
Settings screen ....................................................................................3-19
User Counter ....................................................................................3-19
Automatic elevator............................................................................3-20
Changing the volume........................................................................3-20
Application Overrides........................................................................3-21
Selecting your scanning application ........................................................3-27
Getting your scanner
ready to scan
1. Be sure the scanner is on and ready to scan (Start/Pause button LED is
green and constant).
2. Adjust the input elevator to meet your scanning needs. See the section
entitled, “Adjusting the input elevator” for more information.
3. Adjust the output tray to meet your scanning needs. See the section
entitled, “Adjusting the output tray” for more information.
4. Select your scanning application.