4 Customer Support: http://www.pandigital.net/kodaksupport
Introduction
Now you can scan your printed photos and negative films and store them on your memory card. No computer is necessary. Simply
insert a memory card into the scanner, and power it on. When the unit is ready, feed your printed photo or negative film into the
scanner and your pictures will be stored on the memory card. It’s as easy as that.
If you want to transfer your photos directly into your PC, it’s just as easy via a USB cable and our Scan PC Software (page 12).
Scanner Overview
Front View
No. Name Function/ Description
Power Button
Press once to turn on in 600dpi mode; press again for 300dpi mode.
Press and hold for 2 seconds to turn off.
Press and hold for more than 6 seconds to enter cleaning mode. (Refer to "Cleaning the
Scanner" on page 15.)
Power Indicator Indicates the power status of the scanner. (Refer to “Indicator Lights” on page 5.)
Status/Card Indicator
Indicates the operating status of the scanner and memory card. (Refer to “Indicator Lights”
on page 5.)
Paper Guide Slide Slide the guide to adjust for smaller than 4x6” originals to ensure the proper alignment.
Feed Slot Insert an original photo into this slot to begin scanning.
Adapter Grooves For installing the 35mm Negative adapter.
Orientation guide Indicates the correct position and orientation of the original for proper scanning.
Rear View
No. Name Function/ Description
SD/xD/MMC/
MS Card slot
Accepts the following types of memory cards: SD, xD, MMC and MS. Also accepts
MICROSD Cards with an SD adapter. (Refer to "Supported Memory Cards" on page 6.)
Output slot The scanned original exits from this slot.
Mini USB connector For connecting to a computer via a USB cable.
Power connector For connecting to the supplied power adapter.
To Next Page
Loading...
