A-61760 September 2012 4-7
4. Select Continue.The Scan Images screen will be displayed. The
Scanning Completed button will be active if the order already
contains photos to allow you to proceed to the following screens.
5. Place a batch of photos in the scanner’s input tray (for a Batch
Scan) or as a single photo on the flatbed platen (for a Flatbed
Scan). Be sure the photos you want to scan are facing up properly.
NOTES:
• For best feeding performance always scan the photos with the
scanner body tilted to the downward position and with photos
face up and oriented as shown below.
• Photos will be fed into the scanner from the bottom of the stack.
Therefore, if you want your photos scanned in a specific
sequence, feed your photos as described in the section entitled,
“Getting your photos ready to scan” earlier in this chapter.
To Next Page
Loading...
