Kodak RVG 6500 IPS System - Page 18

14 Chapter 2 Regulatory Information
Guidance and Manufacturer’s Declaration - Electromagnetic Immunity
(IEC 60601-1-2)
The KODAK RVG 6500 with or without IPS System is intended for use in the
electromagnetic environment specified below. The customer or the user of the KODAK
RVG 6500 with or without IPS System should assure that it is used in such an
environment.
Immunity
Tes t
IEC 60601
Test Level
Compli
ance
Level
Electromagnetic Environment - Guidance
Conducte
d RF
IEC
61000-4-6
Radiated
RF
IEC
61000-4-3
3 Vrms
150 kHz to
80 MHz
3 V/m
80 MHz to
2,5 GHz
[V1]= 3
V
[E1]= 3
V/m
Portable and mobile RF communications equipment
should be used no closer to any part of the KODAK
RVG 6500 with or without IPS System, including
cables, than the recommended separation distance
calculated from the equation applicable to the
frequency of the transmitter.
Recommended separation distance
where P is the maximum output power rating of the
transmitter in watts (W) according to the transmitter
manufacturer and d is the recommended separation
distance in metres (m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey should
be less than the compliance level in each frequency
range.b
Interference may occur in the vicinity of equipment
marked with the following symbol:
NOTE 1: At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects and people.
a Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless)
telephones and land mobile radios, amateur radio, AM and FM radio broadcast and TV
broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic
environment due to fixed RF transmitters, an electromagnetic site survey should be
considered. If the measured field strength in the location in which the KODAK RVG 6500
with or without IPS System is used exceeds the applicable RF compliance level above, the
KODAK RVG 6500 with or without IPS System should be observed to verify normal
operation. If abnormal performance is observed, additional measures may be necessary,
such as re-orienting or relocating the KODAK RVG 6500 with or without IPS System.
b Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.