Setting Up Your Kodak ScanMate i1120 Scanner to Work with DYMO File
6 © 2008 Newell Rubbermaid. All Rights Reserved
Using the First Run Wizard
The First Run Wizard runs automatically the first time you start DYMO File. If you have
already completed the First Run Wizard, save time by skipping this procedure and using
DYMO File Settings instead, as described beginning on page 7.
To use the First Run Wizard
1 Start DYMO File.
2 If the wizard doesn’t open automatically, start it by choosing Tools > First Run
Wizard.
3 Follow the wizard’s on-screen instructions to do the following:
a Identify the printer you will use to print a test barcode.
b Print a test barcode.
4 In the Select Scanner Type dialog box, select My Network.
Select this option even if the ScanMate i1120 scanner is connected directly to your
computer.
5 Click Next twice to bypass the instructions in the Set Up Scanner dialog box.
The Set Up Scanner dialog box provides general information that applies to all
scanners; however, ScanMate-specific instructions are provided in this document in
“Configuring Smart Touch for DYMO File Scanning” starting on page 1.
My Network option
General information for
all supported scanners
To Next Page
Loading...
