To Next PageTo Next PageWhy is the scanning density uneven on my Kodak Scanner?
Uneven scanning density on your Kodak Scanner could be due to dirty ADF glass areas, reference plates, flatbed glass, or flatbed sheet. Clean these components. Also, the distribution of the quantity of light in the scan may vary, perform the shading adjustment.
Why is the scanning speed so slow on my Kodak Truper 3210 Scanner via USB?
If the scanning speed is too slow when using a USB connection with your Kodak Scanner, it could be that the scanner is connected with a USB 1.1 interface. Verify the type of USB interface and connect with a USB 2.0 interface for faster scanning speeds.
Why is my Kodak Scanner producing blank scans?
If your Kodak Scanner is producing blank scans, it is likely that the document to be scanned was loaded facing down (upside down). Load the document properly.
Why doesn't the LED light up on my Kodak Scanner when I turn it on?
If the LED doesn't light up when you turn on your Kodak Scanner, it could be due to the power cord not being plugged in properly or a problem with the power supply. Ensure the power cord is firmly inserted into the power outlet and the scanner. If the problem persists, disconnect the scanner from the power outlet and call for service.
Why is my Kodak Truper 3210 not connecting to my computer?
If your Kodak Scanner is not connecting, it could be due to several reasons: the scanner isn't connected, the scanner isn't turned on, or the computer was turned on before the scanner was ready. To resolve this: - Connect the scanner to the computer. - Turn on the scanner. - Restart the computer.
Why does my Kodak Scanner say the rollers need to be replaced?
The message indicating that the rollers need to be replaced appears because the warning counter has expired. Replace the rollers, and after replacing the rollers, return to the User Utility and click the Clear Counter button for “After Replace Roller.”
What to do if a document remains stuck in my Kodak Scanner?
If a document remains in the Kodak Scanner, it could be due to the document remaining in the scanner or dirty document sensors. Open the ADF and exit doors and remove the paper. Clean the sensors.
How to fix a skewed image from my Kodak Scanner?
A skewed image from your Kodak Scanner can occur if the document guides are not adjusted to the size of the document or if the document is positioned at a slant on the feeder tray. Adjust the document guides properly to the size of the document and straighten the document on the feeder tray. Also, remove any curls or folds, reduce the number of sheets to be scanned, and load the document again.
Why are there vertical lines on my scanned documents from my Kodak Truper 3210?
Vertical lines on scanned documents from your Kodak Scanner may appear if the ADF glass areas or the flatbed glass is dirty. It may also be caused by dirty reference plates or a dirty flatbed sheet. Clean the ADF glass areas and the flatbed glass. Also, clean the reference plates and the flatbed sheet.
Why does my Kodak Truper 3210 Scanner say the rollers need to be cleaned?
The message indicating that the rollers need to be cleaned appears because the warning counter has expired. Clean the rollers, and then return to the User Utility and click the Clear Counter button for “After Clean Roller.”
General
