To Next Page
J
John ColemanSep 9, 2025
Why is my Kodak Truper 3210 Scanner scanning so slow via USB?
- RRobert NealSep 10, 2025
To resolve slow scanning speeds with your Kodak Scanner via USB, verify that the scanner is connected using a USB 2.0 interface.
Why is my Kodak Truper 3210 Scanner scanning so slow via USB?
To resolve slow scanning speeds with your Kodak Scanner via USB, verify that the scanner is connected using a USB 2.0 interface.
What to do if my Kodak Scanner is double feeding?
If your Kodak Scanner is experiencing a double feed error, it could be due to a double feed error or dirty rollers. Open the ADF and exit doors to remove any jammed paper. Additionally, clean the rollers to resolve this issue.
How do I get my computer to recognize my Kodak Scanner?
If your computer isn't recognizing the Kodak Scanner, there might be a connection or configuration issue. Ensure the interface cable is properly connected. Also, the scanner may not have been properly configured using the Windows “Found New hardware” procedure. Check that the USB interface of the computer is installed properly using the Windows Device Manager. Avoid connecting the scanner to a USB hub and use the cable provided with the scanner.
How to fix Kodak Truper 3210 Scanner error U20?
If your Kodak Scanner displays error U20, open the ADF and exit doors and remove the jammed paper.
What to do if my Kodak Scanner ADF double feeds or skews documents?
If your Kodak Scanner's ADF frequently double feeds, skews documents, or stops feeding during scanning, the rollers may be dirty or worn out. Clean the rollers and check them for wear. Also, ensure that the documents aren't curled or folded; if they are, flatten them, reduce the number of sheets in the feeder tray, and reload the document.
Why does the scanned document color look wrong on my Kodak Truper 3210?
If the color of the scanned document is very different from the original when using your Kodak Scanner, adjust the computer display and monitor settings.
Why is the scanning density uneven on my Kodak Scanner?
Uneven scanning density on your Kodak Scanner could be due to dirty ADF glass areas, reference plates, flatbed glass, or flatbed sheet. Clean these components. Also, the distribution of the quantity of light in the scan may vary, perform the shading adjustment.
Why won't the ADF door open on my Kodak Truper 3210?
If the ADF door on your Kodak Scanner does not open when the release is pushed, it might not be closed properly. Push the ADF door release button and lift up the ADF door. Close the ADF door securely until it is locked, but do not slam it.
How do I clear the roller replacement warning on my Kodak Truper 3210?
To clear the roller replacement warning on your Kodak Scanner, replace the rollers. After replacing the rollers, return to the User Utility and click the Clear Counter button.
Why are there vertical lines on my scanned documents from my Kodak Truper 3210?
Vertical lines on scanned documents from your Kodak Scanner may appear if the ADF glass areas or the flatbed glass is dirty. It may also be caused by dirty reference plates or a dirty flatbed sheet. Clean the ADF glass areas and the flatbed glass. Also, clean the reference plates and the flatbed sheet.
General
