How do I clear the roller cleaning warning on my Kodak Truper 3210 Scanner?
To clear the roller cleaning warning on your Kodak Scanner, clean the rollers. After cleaning the rollers, return to the User Utility and click the Clear Counter button.
How do I clear the roller replacement warning on my Kodak Truper 3210?
To clear the roller replacement warning on your Kodak Scanner, replace the rollers. After replacing the rollers, return to the User Utility and click the Clear Counter button.
What to do if a document remains stuck in my Kodak Scanner?
If a document remains in the Kodak Scanner, it could be due to the document remaining in the scanner or dirty document sensors. Open the ADF and exit doors and remove the paper. Clean the sensors.
What to do if my Kodak Scanner is double feeding?
If your Kodak Scanner is experiencing a double feed error, it could be due to a double feed error or dirty rollers. Open the ADF and exit doors to remove any jammed paper. Additionally, clean the rollers to resolve this issue.
How do I get my computer to recognize my Kodak Scanner?
If your computer isn't recognizing the Kodak Scanner, there might be a connection or configuration issue. Ensure the interface cable is properly connected. Also, the scanner may not have been properly configured using the Windows “Found New hardware” procedure. Check that the USB interface of the computer is installed properly using the Windows Device Manager. Avoid connecting the scanner to a USB hub and use the cable provided with the scanner.
Why is my Kodak Truper 3210 Scanner double feeding, skewing, or stopping during scanning?
Frequent double feeding, skewing, or scanner stoppages during scanning can be caused by dirty rollers, rollers that have reached their life expectancy, curled or folded documents, irregular document types, or documents shorter than 2.75 inches. Clean all the rollers. If that doesn't help, replace the paper feed roller module and the retard roller module. Flatten the document, reduce the number of sheets to be scanned and load the document again. Use the flatbed scanner if you are scanning an irregular type of document or the document has a length of less than 2.75 in. (70 mm).
What to do if my computer does not recognize the Kodak Truper 3210 Scanner?
If your computer isn't recognizing the Kodak Scanner, ensure it's properly connected directly to the computer, not through a USB hub. Also, make sure you're using the USB cable provided with the scanner, and that it doesn't have a High Speed logo. If the scanner wasn't properly configured initially, uninstall and reinstall the scanner driver, following the Windows 'Found new hardware' procedure. Finally, check your computer's USB interface in the Windows Device Manager to ensure it's installed correctly.
How to fix Kodak Truper 3210 Scanner when the LED doesn't light up?
First, check that the power cord is securely plugged into both the power outlet and the scanner's power input. If the LED still doesn't light up, there might be a problem with the power supply, disconnect the scanner from the power outlet and call Service.
How to troubleshoot Kodak Scanner when it is not connected?
If your Kodak Scanner is not connecting, ensure the scanner is connected to the computer, turn on the scanner and restart the computer. If the scanner is not turned on, turn the scanner on and then restart the computer. If the computer was turned on before the scanner was ready, restart the computer.
How to fix a paper jam in my Kodak Truper 3210?
If a jam occurs in your Kodak Scanner, it could be due to a document jam or dirty document sensors. Open the ADF and exit doors to remove the jammed paper. Also, clean the sensors to ensure proper function.
To Next Page
General
