What to do if a document remains stuck in my Kodak Scanner?
If a document remains in the Kodak Scanner, it could be due to the document remaining in the scanner or dirty document sensors. Open the ADF and exit doors and remove the paper. Clean the sensors.
Why is my Kodak Truper 3210 Scanner scanning so slow via USB?
To resolve slow scanning speeds with your Kodak Scanner via USB, verify that the scanner is connected using a USB 2.0 interface.
Why are there vertical lines on my scanned documents from my Kodak Truper 3210?
Vertical lines on scanned documents from your Kodak Scanner may appear if the ADF glass areas or the flatbed glass is dirty. It may also be caused by dirty reference plates or a dirty flatbed sheet. Clean the ADF glass areas and the flatbed glass. Also, clean the reference plates and the flatbed sheet.
How do I clear the roller replacement warning on my Kodak Truper 3210?
To clear the roller replacement warning on your Kodak Scanner, replace the rollers. After replacing the rollers, return to the User Utility and click the Clear Counter button.
How to remove dark spots or noise from scanned documents using Kodak Scanner?
To remove dark spots or noise from scanned documents when using your Kodak Scanner, clean the imaging guides (or flatbed glass) and background bars.
Why does the scanned document color look wrong on my Kodak Truper 3210?
If the color of the scanned document is very different from the original when using your Kodak Scanner, adjust the computer display and monitor settings.
How to fix Kodak Truper 3210 Scanner error U20?
If your Kodak Scanner displays error U20, open the ADF and exit doors and remove the jammed paper.
What to do if my computer does not recognize the Kodak Truper 3210 Scanner?
If your computer isn't recognizing the Kodak Scanner, ensure it's properly connected directly to the computer, not through a USB hub. Also, make sure you're using the USB cable provided with the scanner, and that it doesn't have a High Speed logo. If the scanner wasn't properly configured initially, uninstall and reinstall the scanner driver, following the Windows 'Found new hardware' procedure. Finally, check your computer's USB interface in the Windows Device Manager to ensure it's installed correctly.
Why is my Kodak Truper 3210 Scanner double feeding, skewing, or stopping during scanning?
Frequent double feeding, skewing, or scanner stoppages during scanning can be caused by dirty rollers, rollers that have reached their life expectancy, curled or folded documents, irregular document types, or documents shorter than 2.75 inches. Clean all the rollers. If that doesn't help, replace the paper feed roller module and the retard roller module. Flatten the document, reduce the number of sheets to be scanned and load the document again. Use the flatbed scanner if you are scanning an irregular type of document or the document has a length of less than 2.75 in. (70 mm).
How do I get my computer to recognize my Kodak Scanner?
If your computer isn't recognizing the Kodak Scanner, there might be a connection or configuration issue. Ensure the interface cable is properly connected. Also, the scanner may not have been properly configured using the Windows “Found New hardware” procedure. Check that the USB interface of the computer is installed properly using the Windows Device Manager. Avoid connecting the scanner to a USB hub and use the cable provided with the scanner.
To Next Page
General
