Why won't the ADF door open on my Kodak Truper 3210?
If the ADF door on your Kodak Scanner does not open when the release is pushed, it might not be closed properly. Push the ADF door release button and lift up the ADF door. Close the ADF door securely until it is locked, but do not slam it.
Why doesn't my Kodak Truper 3210 Scanner start scanning when a document is loaded?
If your Kodak Scanner doesn't start scanning when a document is loaded, it could be that the document is not loaded properly or the sensor cannot detect the document because the edge of the document is curled. Load the document properly. If the document is curled, flatten it and load it again.
What to do if my Kodak Truper 3210 says the door is open?
If your Kodak Scanner indicates that the door is open, it means the ADF door is open. Close the ADF door, but do not slam it.
Why does my Kodak Truper 3210 say the front reference plate needs cleaning?
The message indicating that the front reference plate may need to be cleaned appears because the front reference plate is dirty. Clean the front reference plate.
To Next Page
General
