Cleanup and Periodic Maintenance
7C8770 – 19JAN99 19
Figure 16 Splash Guard and Drip Tray
Caution
When installing the Racks, use the Splash Guard. Lower the Racks slowly.
[6] Install the Racks, the Crossover Assemblies, and the Dryer Assembly. Check that each Assembly seats firmly.
[7] Turn on the main power, the water, and the Processor.
[8] Check the solutions. If the surfaces of the solutions are moving, the Recirculation Pumps are operating.
[9] When the Temperature Ready Light flashes, use a thermometer of known accuracy and check the solution
temperature in the developer Tank.The correct temperature is:
Standard Cycle 33.3 0.3°C (92.0 0.5°F)
Rapid Cycle 34.4 0.3°C (94.0 0.5°F)
H172_1003AC
H172_1003ACA
SPLASH GUARD
DRIP TRAY
To Next Page
Loading...