OPERATORS MANUAL
6 19JAN99 – 7C8770
Feeding Sheet Film
Figure 4 Film Sizes and Direction of Film Feed
[1] Press the Run/Standby Switch.
Note
• The Motors will begin to operate.
• After film removal, the Processor will automatically
return to the standby mode.
• The Temperature Ready Light flashes or turns off
when the developer solution is at the correct
temperature for processing film.
[2] Feed a sheet of film into the Processor.
Note
• Insert single-emulsion films with the emulsion side
up.
• A film feed signal will sound 3 seconds after the
trailing edge of a sheet of film has left the Rollers of
the Detector Crossover Assembly.
Feeding Roll Film
Caution
• Use only
3M SCOTCH
Brand Polyester Film Tape No. 850. Other types of tape are unacceptable, because their
bases are soluble in the processing solutions.
• The adhesive side of the tape must not be exposed.
[1] Use a sheet of film as a leader.
[2] Use 2 cm (1 inch) wide
3M SCOTCH
Brand Polyester Film Tape No. 850 to connect the sheet of film to the roll
film.
H172_1002CC
or
or
18 x 24 cm
1 each
11 x 14 in.
4 x 4 in.
or
10 x 10 cm
2 each
18 x 43 cm
1 each
24 x 24 cm
1 each
10 x 12 in.
24 x 30 cm
1 each
1 each
14 x 14 in.
35 x 35 cm
1 each
14 x 17 in.
or
35 x 43 cm
1 each
To Next Page
Loading...