Processing Film
7C8770 – 19JAN99 5
Figure 3 Racks and Crossovers
[5] Install the Top Cover on the Processor.
[6] Allow the developer solution to reach the correct
temperature.
Recommended developer temperatures:
Note
The Temperature Ready Light flashes or turns off when
the developer solution is at the correct temperature.
[7] Press the Run/Standby Switch.
[8] When the Temperature Ready Light flashes, feed
a sheet of
Kodak
Roller Transport Cleanup Film
into the Processor.
[9] Adjust the Dryer Temperature Control Knob to the
lowest setting to dry the film.
H172_1001CC
RACK
DEVELOPER
RACK
FIXER
RACK
WASH
ASSEMBLY
CROSSOVER
FIXER/WASH
CROSSOVER ASSEMBLY
DEVELOPER/FIXER
ASSEMBLY
DRYER
ASSEMBLY
CROSSOVER
DETECTOR
FEED SHELF
H172_1001CCA
Cycle type Developer Temperature
Standard 33.3 0.3°C (92.0 0.5°F)
Rapid 34.4 0.3°C (94.0 0.5°F)
To Next Page
Loading...