Kodak X-Omat 2000 - Processing Film; Start-Up

OPERATORS MANUAL
4 19JAN99 – 7C8770
Section 2: Processing Film
Start-Up
Figure 1 Main Power Switch
Warning
Keep fingers, clothing, cleaning materials, etc., away
from the moving parts of the Processor.
[1] Turn on the water supply and the Main Power
Switch.
[2] Remove the Top Cover.
Figure 2 Water Inlet Tube of the Wash Tank
[3] Check the following are seated correctly.
(See Figure 3.)
• Developer Rack
• Fixer Rack
• Wash Rack
• Fixer/Wash Crossover Assembly
• Developer/Fixer Crossover Assembly
• Detector Crossover Assembly
• Dryer Assembly
[4] Check:
• developer, fixer, and wash solutions are at the
overflow level of the Weirs
• water is flowing from the Water Inlet Tube of
the Wash Tank
• Evaporation Covers are installed
H172_0501AC
H172_0501ACC
SWITCH
RUN/STANDBY
TOP COVER
MAIN POWER SWITCH
TEMPERATURE
READY LIGHT
RUN/STANDBY
SWITCH
H172_1000AC
H172_1000ACA
KNOB
CONTROL
TEMPERATURE
DRYER
COVER
TOP
COVERS
2 EVAPORATION
WATER
INLET TUBE