Kodiak Recirculating Chiller Technical Manual
Manual # 820-0109, Rev. Y, 07/08/10 - 4 - Check Lytron’s website www.Lytron.com
for the most current technical information.
INTRODUCTION
Receiving the New Kodiak
Chiller
Inspect the new chiller immediately upon receiving it. If the unit shows shipping damage, contact the
transportation company and file a freight damage claim. Retain all cartons and packing material until the unit is
operated and found to be in good condition. The chiller has been fully tested at the Lytron factory with clean
water. Although the system has been drained, some residual fluid may remain. This will not hinder the
performance of the chiller.
About the Warranty
All units returned for warranty claims must have an RMA (Return Material Authorization) number on the outside
of the container. Call Lytron Customer Service at
+1-781- 933-7300 for an RMA number. Refer to the end of
manual for the chiller warranty. Units should be drained of all fluids and packaged in its original packaging.
Customer Service Support
Lytron is committed to servicing the customer, both during and after the sale. If you have any questions
concerning the operation of your unit, contact our Application Engineering Department at
+1-781- 933-7300.
To facilitate your call, please have the model number
and serial number of the unit (located on the rear of the
chiller) for the Lytron Applications Engineer.
Service Hotline
Lytron has a 24-hour per day, 7 day per week service hotline to help you with questions on the startup and
operation of your Kodiak recirculating chiller. (Lytron recommends consulting the troubleshooting guide
on page 29 before calling the service hotline.) Lytron service can be reached by dialing
+1-781- 933-7300.
To facilitate your call please have the model number
and serial number (located on rear of the chiller) of the
unit for the Lytron Service Technician.
Kodiak is a registered trademark of Lytron, Inc.
To Next Page
Loading...
Need help?
General
