TP-6196 10/09 103Section 7 Disassembly/Reassembly
GM57149
L0
1
2
3
1. Line circuit breaker
2. Neutral (L0)
3. Ground terminal
4. SCR module
5. Fuses
Junction Box Detail
5
4
Figure 7-5 Alternator Connections inside Controller
Box, ADC-RES
ADV-7466
1
1. Engine exhaust muffler
2. Muffler bolts
3. Heat shield
4. Flange connection
5. Heat shield bolts
432
5
Figure 7-6 Muffler and Heat Shield
4. Remove the exhaust shield and alternator air inlet
duct. See Figure 7-7.
1
GM29253
1. Exhaust shield screws
2. Alternator air inlet duct screws
2
Top View
Figure 7-7 Shield and Alternator Air Inlet Duct,
Top View
a. Remove two bolts securing the exhaust shield
at the exhaust end and remove the shield.
b. Remove three bolts securing the alternator air
inlet duct to the base and remove the duct.
5. Remove the alternator end bracket.
a. Remove the nuts securing the alternator end
vibromount mounting plate to the skid. See
Figure 7-8.
GM29253A-F
1
1. Alternator end vibromount
Figure 7-8 Generator Set, Right Side (typical)
To Next Page
Loading...
Need help?
General
