TP-6984 5/17a 31Section 1 Installation
1.15 OnCue Plus Generator
Management System
The OnCuer Plus Generator Management System is
included with the 8RESV(L), 10RESV(L), and
12RESV(L) and allows monitoring and control of your
generator set from a personal computer, smart phone,
or tablet. OnCue Plus can also be configured to send
email or text message notifications in the e vent of a
generator set fault. See G18-247, Quick Start Guide and
TP--6928, OnCue Plus Operation Manual, for
instructions.
To use OnCue Plus, you must have the following
minimum requirements for connecting your generator to
the Internet:
D “Always-on” Internet service for generator set
connection (for example, cable, DSL, or phone line
modem connected 24 hours)
D Unused Ethernet port on a switch, router,or modem
D An uninterruptible power supply (UPS) for the modem
and router is recommended.
D 5E customer-supplied network cable for connection
of the generator set to the customer’s Ethernet router
(see installation instructions in Section 1.9.3)
D USB cable, male USB A to male mini-B, for updating
the controller firmware.
For instructions on connecting the network cables to the
generator set, see instructions in Section 1.9.3.
To Next Page
Loading...
Need help?
General
