TP-6984 5/17a 9
Introduction
This manual provides installation instructions for Model
8/10/12RESV or 8/10/12RESVL generator sets. See
Figure 1 . Refer to TP-6880, Operation Manual, for
generator set operation and maintenance instructions.
The generator set is approved for use in stationary
applications in locations served by a reliable utility
power source.
Have a Kohlerr authorized distributor/dealer install the
generator set outdoors according to the instructions in
this manual. The generator set installation must comply
with the National Electrical Code (NEC) and local code
requirements. Do not install this generator set indoors.
Information in this publication represents data available
at the time of print. Kohler Co. reserves the right to
change this publication and the products represented
without notice and without any obligation or liability
whatsoever.
Read this manual and carefully follow all procedures
and safety precautions to ensure p roper equipment
operation and to avoid bodily injury. Read and follow the
Safety Precautions and Instructions section at the
beginning of this manual.
Figure 1 Model RESV Generator Set
List of Related Literature
Figure 2 identifies related literature available for the
generator sets covered in this manual. Only trained and
qualified personnel should install or service the
generator set.
Literature Type Part Number
Spec Sheet, 8RESV G4--252
Spec Sheet, 8RESVL G4--253
Spec Sheet, 10/12RESV G4--254
Spec Sheet, 10/12RESVL G4--255
Operation Manual, Generator Set TP-6880
Operation/Installation Manual, Model
RXT Automatic Transfer Switch
TP-6807
Operation Manual, OnCuer Plus
Software
TP-6928
Operation Manual, SiteTecht
Software
TP-6701
Operation/Installation Manual,
Model RDT Transfer Switch
TP-6345
Installation Instructions,
Programmable Interface Module (PIM)
TT-1584
Installation Instructions, Load Shed Kit TT-1609
Installation Instructions, USB Utility TT-1636
Figure 2 Related Literature
Startup and Registration
When the generator set is installed, complete the
startup and installation checklists supplied with the
startup notification form. Complete the startup
notification form and register the unit using the Kohler
online Warranty Processing System.