What to do if my Kohler 14RESA Portable Generator shows a fault shutdown?
If your Kohler Portable Generator displays a fault shutdown message on the controller, identify and correct the cause of the fault condition. Then, press the OFF button on the controller to clear the fault.
What to do if the thermostat tripped on my Kohler 14RESA Portable Generator?
If the thermostat trips on your Kohler Portable Generator, check for blocked air inlets and exhaust outlets. Then, follow the instructions to reset the thermostat.
How to fix engine hunting on Kohler 14RESA models 20RESA(L) and 20RESC(L)?
To address engine hunting in Kohler Portable Generator models 20RESA(L) and 20RESC(L), update to the most current version of firmware available. Also, install vent tubes on the two reference ports on the fuel regulator.
What to do if my Kohler 14RESA Portable Generator has an Over Crank fault?
If your Kohler Portable Generator experiences an Over Crank fault, check the fuel supply, cranking circuit, and cranking battery. You may also need to troubleshoot the engine.
General| Voltage | 120/240V |
|---|---|
| Frequency | 60 Hz |
| Fuel Type | Gasoline |
| Engine | Kohler |
| Phase | Single Phase |
| Starting System | Electric |
| Warranty | 3 years limited |
Details hazards and procedures to prevent accidental generator starting.
Covers safety precautions for handling batteries, acid, and gases.
Warns about fire hazards from engine backfire and fuel leaks.
Addresses carbon monoxide hazards and exhaust system integrity.
Highlights dangers of hazardous voltage, moving parts, and fuel system safety.
Covers safety for lifting equipment and hot engine/exhaust components.
Details safety procedures for accidental starting and hazardous voltage.
Outlines maintenance tasks, frequency, and routine service based on operating conditions.
A table detailing maintenance tasks, frequency, and corresponding sections.
Provides general information, maintenance, and cleaning instructions for the battery.
Explains procedures for reconnecting generator set stator leads for different voltages.
Explains the use of SiteTech software for controller configuration and firmware updates.
Introduces adjustable parameters and notes on selected settings like temperature and engine speed.
Provides instructions for replacing the RDC2 or DC2 controller, including important notes.
Details the procedure for setting controller parameters after installation.
Explains how to check and adjust voltage calibration using keypad or SiteTech.
Guides on troubleshooting common fuel system problems related to pressure and regulator function.
Provides a sequence to diagnose and resolve engine hunting issues.
Lists fault messages, their descriptions, and recommended checks, including overload conditions.
Lists fault messages related to battery, timing, speed, and thermostat issues.
Lists warning messages and events related to paralleling systems.
A reference table for troubleshooting individual problems, causes, tests, and corrective actions.
Provides a table for troubleshooting controller issues like display problems and communication loss.
Guides on troubleshooting issues with load management devices and controller recognition.
Covers alternator excitation, including no/low voltage, erratic regulation, and separate excitation.
Explains how to adjust voltage and configure voltage regulator settings.
Verifies the operation of overspeed, overcrank, and low oil pressure shutdowns.
Highlights critical safety warnings for disassembly procedures.
To Next Page
