TP-7092 8/1844 Section 3 RDC2 Controller Operation
3.17 Date and Time Menu
The date and time will typically be set at controller
power--up. To change the date, time, or time format
(12 hour or 24 hour), use the Date and Time menu.
See Figure 3-18.
3.18 Networking Information Menus
Use the networking menus to view and adjust
communication settings for systems with remote RBUS
devices such as a PIM or load shed kit, and for systems
that use the Kohler OnCuer Plus Generator
Management System.
RBUS is a proprietary RS-485 communications
protocol.
The Networking Information menu leads to submenus
for network and RBUS communication settings.
tp6804
Date:
02Dec2011
Time:
12:34pm
Time Format:
12hr|24hr
Date and
Time
To change the date and time, press the Select button
See Figure 3-7 for instructions.
<---- Return
Figure 3-18 Date and Time Menu
tp6810
Networking---->
Information
Networking---->
Status
NS
RBUS ---->
Information
RB
<---- Return
Networking---->
Configuration
NC
See Figure 3-20.
See Figure 3-21.
See Figure 3-22.
Figure 3-19 Networking Information Menu
To Next Page
Loading...
Need help?
General
