TT-1715 2/17 7
The normal mode will display only the following
parameters when the generator set is NOT running:
D Hours
D Battery Voltage
Among the status parameters is an indicator shown as
an asterisk used to indicate when the generator set is
running. This generator running indicator is located on
the hours screen and is shown before the
characters HRS.
Note: If the generator is running, each asterisk
segment will blink on and off in a clockwise
direction. If the generator is not running, all
asterisk segments will remain on and will
not blink.
D Start/Stop Mode: Allows remote starting and
stopping of the generator set engine. See Section 9,
Generator Start/Stop, for operation sequence.
D Sleep Mode: After one hour of generator set and
gauge inactivity, the backlight display turns off.
D Fault Mode: Displays the fault and warning codes as
shown when a fault or warning condition is detected.
To clear the fault code see Section 14.
1 2
3
1. LCD Initial Three Second Wakeup
2. LCD Normal (Hours Screen)
3. LCD Fault
4. LCD Warning
5. LCD Start
6. LCD Sleep
4
6
5
*
Figure 12 Gauge LCD Screen Displays
To Next Page
Loading...
