TP-6842 7/15 Introduction 9
Introduction
This manual provides installation instructions for the
DC (direct current) variable speed Model 6VSG
generator set. Refer to TP-6843, Operation Manual,
for generator set operation and maintenance
instructions.
This generator set is approved for use in stationary
applications in locations served by a public utility,
photovoltaic cells, wind turbines, or any combination of
power sources tied to a battery bank.
Have an authorized distributor/dealer install the
generator set outdoors according to the instructions in
this manual. The generator set installation must
comply with the National Electrical Code (NEC) and
local code requirements. Do not install this generator
set indoors.
Information in this publication represents data
available at the time of print. Kohler Co. reserves the
right to change this publication and the products
represented without notice and without any obligation
or liability whatsoever.
Read this manual and carefully follow all procedures
and safety precautions to ensure proper equipment
operation and to avoid bodily injury. Read and follow
the Safety Precautions and Instructions section at the
beginning of this manual.
List of Related Literature
Figure 1 identifies related literature available for the
generator sets covered in this manual. Only trained
and qualified personnel should install or service the
generator set.
Figure 1
Figure 1 Related Literature
Startup and Registration
When the generator set is installed, complete the
startup and installation checklists supplied with the
startup notification form. Complete and sign the
startup notification form and register the unit using the
Kohler online Warranty Processing System.
Literature Type Part Number
Operation Manual, 6VSG
Generator Set TP-6843
Service Manual, 6VSG Generator Set TP-6844
Operation Manual, OnCue
®
Software
TP-6796
Operation Manual, SiteTech
™
Software
TP-6701
Installation Instructions,
Programmable Interface Module (PIM) TT-1584
To Next Page
Loading...
Need help?
General
