Kohler APM402

TP-6694 9/20 165
Description
Controller
Display
Message
Write
Access
Display
SiteTech
GenSet
Mode
Always
Running
Stopped
Range
Setting
Default
Selection
Time
Delay
Range
(sec.)
Default
Time
Delay
(sec.)
Programmer-
Defined
Settings
Voltage regulator, volts
per Hertz slope
S
R
1-10
5
Voltage regulator, volts
per Hertz cutin
frequency
S
R
42-62
57.5
* Some functions require optional input sensors or are engine ECM dependent on some generator set models.
# ECM inputs are engine manufacturer dependent.
] Changeable only by resetting the controller with a personality profile (SiteTech 1.4 or higher).
** Denotes the default parameter range. Typically, ranges for the NiCad battery topology are slightly wider. For more details, refer to the
battery charger operation manual.
ST- Short Term, LT- Long Term