INFORMATION ABOUT USE
4
25
EN
Internal Communication: For internal & partner use only.
4.5 Oil filling
•
For safety precautions see Par. 2.4.
•
Before proceeding with operation, read Par. 3.2.2.
•
Do not use the engine with the oil level below the minimum.
1.
Loosen the oil filler cap A or the oil filler cap C if the cap A is not
accessible.
2.
Add the type of oil recommended (Tab. 2.1 and Tab. 2.2).
Fig 4.1
3.
Before checking oil engine needs to be level.
4.
Remove the oil dipstick B and check that the level is up to but
does not exceed the MAX.
5.
If level is not at the MAX . level, add additional oil.
6.
Re-tighten the cap A or C.
Fig 4.2
NOTE : Click on the right to play the procedure.
https://youtu.be/Tt4mNQVDzWk
4.6 Coolant filling
•
Before proceeding with operation, read Par. 3.2.2.
Warning
•
An anti-freeze protection liquid (ANTIFREEZE) - mixed with decalcified water - must be used.
•
The freezing point of the refrigerant mixture depends on the amount concentration in water.
•
As well as lowering the freezing point, the antifreeze also raises the boiling point.
•
A 50% mixture is recommended to ensure a general level at protection prevents the formation of rust,
galvanic currents and calcium deposits.
To Next Page
Loading...
Need help?
General