INFORMATION ABOUT REPLACEMENTS
6
39
EN
Internal Communication: For internal & partner use only.
1. Turn the key on the control panel to the ON position.
2. The electric pump D sends fuel to the filter and then the injection
pump E.
3. Loosen the air bleeding screw F on fuel filter bracket B.
4. The air inside the circuit and the filter will begin to escape from
the screw G.
5.
Tighten the bleeding screw F (tightening torque of 1.5 Nm) when
the fuel begins to flow.
NOTE:
Click on the icon to play the procedure.
https://youtu.be/meko2s8_-U0
6.5 Air filter cartridge replacement
•
Before proceeding with operation, read Par. 3.2.2.
NOTE
: Component not necessarily supplied by KOHLER.
1.
Release the two fastenings F of the cover A.
2.
Remove the cartridge B.
3.
Reinstall:
• the new cartridges B.
•
the cover A checking the right tightness of fastenings F.
Fig. 6.10
6.6 Disposal and scrapping
• In case of scrapping, the engine shall be disposed of in appropriate locations, in conformity with the law in
force.
• Before scrapping, it is necessary to separate the rubber or plastic parts from the rest of the components.
• The parts only composed of plastic material, aluminium and steel can be recycled if collected by the
appropriate centers.
• Waste oil must properly be recycled and disposed of in the correct way to safeguard the environment.
According to the laws in force, it is classified as hazardous waste, therefore it must be collected by the
appropriate centers.
To Next Page
Loading...
Need help?
General