การทําความสะอาดหลังการติดตั้ง
CLEANING INSTRUCTIONS
Clean the Filtration System
The faucet includes connector assembly
with high quality filtration system. If there
is a lot of debris in the supply pipes or the
quality of water is bad, it will cause the
flow in bad condition. Please clean the
filtration system as following steps:
1) Turn clockwise the adjustment bolts (30)
on the connector assemblies with the hex
wrench (31), in order to close the connector
assemblies;
2) Screw off the connector caps (33)
counterclockwise with the special key (34);
3) Remove and clean the filters (32), then
reinstall them;
4) Tighten the connector caps (33)
clockwise with the special key (34). Turn
counterclockwise the adjustment bolts (30)
on connector assemblies with the hex
wrench (31).
If necessary,you can screw off and clean
theaerator ofthe faucet,then reinstall it to
improve the flow condition.
NOTE: the strainer must be fit back to the
spout after it is cleaned.
32
33
34
30
31
28
29
Turn the handle to the middle position of
the temp adjusting range (For mixed faucet).
Insert the aerator key (29) into the aerator
slot and take off the aerator (28) by rotating
it counter-clockwise. Put hands into the
sensing range under the outlet. Flush water
through the faucet debris. Remove any
debris from the aerator assembly (28). Shut
the main water supply and reinstall the
aerator assembly (28). Finally, open the
main water supply.
Clean the Aerator Assembly
ทําความสะอาดปากกอก
ทําความสะอาดฟลเตอร
ขอสังเกต:
©2014 Kohler Co.
1115767-X2-A
สําหรับทุกพื้นผิว:
All Finishes: Clean the finish with a mild soap and warm
water. Wipe entire surface completely dry with a clean soft
cloth. Many cleaners may contain chemicals, such as
ammonia, chlorine, toilet cleaner etc. which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler
faucets and fittings.
To Next Page
Loading...
Need help?
General
