TROUBLESHOOTING
Some trouble symptoms can be identified by the indicator's flashing. (Refer to "Note of the Indicator Flashing")
การแกปญหาเบื้องตน
©2014 Kohler Co.
1115767-X2-A
No water flow. 1. No battery or wrongly connected. 1. Check the batteries.
(Indicator not flashing). 2. No power supply or wrong connection. 2. Check the power supply and the conncetion.
3. Object in sensing range. 3. Remove the object.
4. Dirt on the sensing window. 4. Clean the sensing window.
5. The connector does not connect well. 5. Check the connector.
The indicator flashes 1. Batteries are out of power. 1. Replace batteries.
once every 2 seconds 2. Just power cut of AC/DC transformer. 2. Check the power supply.
and the water doesn't 3. DC or AC connector may not 3. Reconnect the connector.
flow out. connect well.
No water flow while 1. Just finishing installation. 1. Wait for 10 minutes.
the indicator flashes 2. The connector assemblies are closed. 2. Open the connector assemblies.
3. Aerator is blocked. 3. Clean the aerator.
4. The filter is blocked. 4. Clean filter.
Low water flow while 1. The connector assemblies are not 1. Turn counterclockwise the adjustment bolts
the indicator does not open completely. on connector assemblies with the hex
flash. 2. The filter is blocked. wrench.
3. Aerator is dirty. 2. Clean filter.
4. The supply water pressure is lower. 3. Clean the aerator.
4. Check the water supply system.
Keep water out within Object in sensing range. Remove object
1 minute while indicator
does not flash.
อาการ สาเหตุที่เปนไปได การแกปญหา
Symptoms Probable Causes Corrective Action
To Next Page
Loading...
Need help?
General
