KohlerPower.com33 590 03 30
6. Install the spark plug.
TIP
If a torque wrench is not available when installing a
spark plug, a good estimate of the correct torque is
1/4–1/2 turn past finger tight. However, the spark plug
should be tightened to the specified torque as soon as
possible.
7. Install the spark plug cap and cap.
8. Install the cover and tighten the screws.
AE00431
Carburetor adjustment
The carburetor is a vital part of the engine. Adjusting
should be left to a Kohler portable dealer with the pro-
fessional knowledge, specialized data, and equipment
to do so properly.
AE00412
Engine oil replacement
Avoid draining the engine oil immediately after
stopping the engine. The oil is hot and should be
handled with care to avoid burns.
1. Place the generator on a level surface and warm
up the engine for several minutes.
Then stop the engine and turn the fuel cock knob,
fuel tank cap air vent knob to OFF.
2. Remove the screws and then remove the cover.
1 Screw
2 Cover
Spark plug tightening torque:
20 Nm (2.0 m·kgf, 14 ft·lbf)
7PB-F8199-L2.indd 30 2014/01/08 17:07:36
To Next Page
Loading...
Need help?
General
