Supply lines and fuse protection must be installed to the list. A master switch provided by the
customer is to be fitted into the supply line (all-pole connector).
Means for disconnection must be incorporated in the fixed wiring in accordance with the
wiring rules.
For the standard type, the electric connection is carried out via a plug connector. The master
switch is not necessary if the connection is made via a plug connector or an outlet.
If Atollspeed is installed as a dual-circuit oven (which means that the units are double
stacked), each baking unit required a separate electrical connection of 16 A each.
The appliance is to be supplied through a residual current device (RCD) having a rated
residual operating current of 30 mA.
Do not plug other devices together with Atollspeed to the same connection. Do not use Multi
Plug connectors. Risk of cable burns!
Extension lines must be rated to carry the rated current of the oven and have the according
wire strength 3 x 2,5mm
"Dangerous voltage — to indicate hazards arising from dangerous
voltages. Note in case of application in a warning sign, the rules
according to ISO 3864 shall be adhered to."
If there is no equipotential bonding conductor in the electric supply, an external
equipotential bonding conductor must be installed at the rear of the appliance (see
symbol).
4.2 Start the oven for the first time
After the Atollspeed has been properly connected, the following points must be accomplished:
Check if the oven has any outside damage. If you see any damage STOP at this point
and contact your reseller or Kolb.
The oven has a safety temperature limiter. This can be triggered from vibration during
transport. The result is that the oven does not heat up. So it maybe necessary to reset
the Safety Temperature limiter before the first start up. Therefore, press the red reset
button under the roof hard.
The baking chamber must be cleaned first with a wet towel. Then heat up the oven to
270ºC and keep this temperature for 30 min. ATTENTION! The oven can be only
heated up without micro-wave function
To Next Page
Loading...
