12
Loosening the sealing nut
Put the combination hook wrench (19) in place as shown on
the figure and loosen the sealing nut.
7 = Sealing nut
19 = Combination hook wrench
Removing the cutting set
Unhock the central extraction bore hole in the combination
hook wrench (19) in the knife journal groove, loosen the
mincer worm including the cutting set, pull them out slightly
and then remove them carefully using both hands.
19 = Combination hook wrench
Removing the mincer casing
Loosen the two securing nuts (18) using the integrated ring
spanner SW24 in the combination hook wrench (19) or both
securing nuts (18) for the new versions, by hand. Swing the
mincer casing to the right until the screwing surface is free
tjem pull the casing forwards carefully using both hands. The
removable mincer casing allows a rapid and thorough
cleaning..
8 = Mincer casing
18 = Securing nut
18 = Securing element (new design)
19 = Combination hook wrench
8 = Mincer casing
18 = Securing nut
18 = Securing element (new design)
To Next Page
Loading...