4
Preparations for Installation
Before you begin, make sure you have all the parts and tools necessary for installation.
Tools You May Need:
• Flat Screwdriver or Putty Knife • Phillips Screwdriver • Tape Measure • Level • Drill
Note: You may need to contact an electrician if your room’s circuit is not able to power your unit.
Note: To avoid risk of injury and / or product / property damage, please take the following
precautions:
• Two or more people are needed to properly handle and install the unit.
• Use proper lifting and carrying techniques.
• Before installation, make sure to inspect the installation location to ensure it is able to handle
the weight and size of this unit.
• Wearing protective gloves will help to avoid injury from sharp edges.
The parts below are intended to be used in conjunction with a Koldfront branded Wall
Sleeve (WTCSLV).
Horizontal Insulation Seals
Vertical Insulation Seals
Horizontal Insulation Seals
1” x 1” x 17” (tapered to ¾”)
Main Insulating Seal (stuffer seal)
Trim Frame (top / bottom)
Toothed washers for grounding screw
Rear Louver Panel / Grille (aluminum)
Additional and / or duplicate parts noted below have been included to allow for installation
into non-Koldfront branded Wall Sleeves or to accommodate non-standard installation
scenarios. Any unused parts may be discarded at your discretion.
Centering / Support Blocks
Horizontal Insulation Seals
Horizontal Insulation Seals