Koldwave Kompac 4WK07 - Page 19

S:\Koldwave\Kompac 4-Series IOM
Koldwave 4830 Transport Drive Dallas, Texas 75247
www.koldwave.com
www.mestekparts.com
19
2. Disconnect sensing probe from Shrader
valve on discharge line. Doing it
quickly will minimize the amount of
refrigerant loss.
3. Remove valve from mounting bracket.
4. Install new valve.
MISCELLANEOUS PARTS
REPLACEMENT AND/OR
ADJUSTMENTS
Part Name
A. High and low pressure switch
B. Compressor run capacitor
C. Start capacitor and relay
D. Freeze control
E. Terminal block
Remove return air grille, filter and
control panel and cabinet panels as
described above.
F. Compressor Overload
Remove return air grille, filter and
control panel on Kompac models. Take
off tope/front panel on model 4WK07.
G. Reversing Valve
H. Reversing Valve Solenoid Coil
Remove front return panel on models
4WK10 to 16. Take off back panel on
4WK20 to 26. Remove entire cabinet on
4WK07.