S:\Koldwave\Kompac 4-Series IOM
Koldwave 4830 Transport Drive Dallas, Texas 75247
www.koldwave.com
www.mestekparts.com
7
easily be removed and cleaned. Just pull the
filter end cap tab at bottom of filter and slide
out.
Discharge Air Grilles
All Kompac series units are equipped with
four, or five 5” x 5”, four-way adjustable,
plastic grilles located in the upper front
panel, enabling a variety of airflow
possibilities. Life panel, enabling a variety
of air flow possibilities. Life each black
grilles (approximately 4/4”) and rotate to the
desired position. Release the grille and
allow it to return to the set position within
the cabinet. By this means air low can be
positioned in any of four directions.
Quick Connect Water Hose
Customer must order one of the four quick
hose kits along with their unit. Each of
these quick connect hose kit will provide
quick and precise water connection to all
Kompac unit.
1) 18” hard pipe kit with dedicated
male NPT fittings.
2) 10-foot hose kit.
3) 20-foot hose kit.
4) 40-foot hose kit.
The 10, 20 and 40-foot hose kit will supply
with hose kit fitting to fit most water faucets
on the water-in line. The water-out and
condensate lines of the three-section flexible
plastic hose can be fed to a sink or
permanent drain.
Service Cord
All Kompac series units are equipped with
LCDI device service cords, which reflects to
the new UL484 standards. The service
cords employed have plug configurations
and receptacle requirements as shown in the
chart below. We strongly recommend user
to follow the plug configurations without
manually altering the pin layout on the plug.
Optional Features
Treated Evaporator Coils
For air conditioning applications
where airborne contaminants are a
problem, acrylic coated evaporator
coils are recommended to guard
against pitting or corrosion.
Remote Control
Optional remote control can provide
extra flexibility to customers. Users
can remotely control all aspect of the
functionality of units (both AC and
Heat Pump unit).
To Next Page
Loading...
