S:\Koldwave\Kompac 4-Series IOM
Koldwave 4830 Transport Drive Dallas, Texas 75247
www.koldwave.com
www.mestekparts.com
6
Standard and Optional Features
Standard Feature
All Kompac series unit has removable
panels to provide full service accessibility.
Each unit comes with standard sliding glides
for ultimate mobility.
Air Flow Flexibility
Air is discharged through four-way
adjustable grilles, enabling a variety of
airflow possibilities. All King Kompac
model five grilles respectively. Washable,
aluminum air filters are installed in each
unit. Periodic cleaning will ensure optimal
unit performance.
Quite, Rugged Cabinet
All Kompac series unit outside panels are
constructed stainless steel finish for rigid
construction.
Automatic Water Valve
All Kompac (air conditioners and heat
pumps) are equipped with a direct acting,
refrigeration system head pressure actuated
water-regulating valve. This valve, set at
the factory for 95 to 100F outlet water
temperature, permits only that amount of
water to follow that is needed to achieve the
desired refrigeration system pressures. In
addition, heat pump models are quipped
with a water bypass solenoid valve to
provide immediate and continuous water
flow on heating.
Safety Engineered
All units incorporate with in the
refrigeration system, a high-pressure switch
for maximum safety of the compressor. The
cutout pressure setting is 375 PSIG +/- 5
PSIG, and it will reset at 265 PSIG. A low-
pressure switch is also included which opens
at 26 PSIG and reset at 68PSIG. During the
heating cycle of the heat pump models, a
freeze control sensor set at 37 +/- 2 F
monitors the water temperature leaving the
condenser to cut-out the unit and protect the
condenser from freezing.
Touch Pad Controls & Remote
All models have self-contained thermostats
to provide the desired amount of cooling,
which can be selected by adjusting the Up
and Down arrows on the unit touch pad or
remote controls. (Please refer to the Unit
Operation for detailed explanation)
Built-In Condensate Pump
Each unit contains a condensate pump for
the positive removal of evaporator
condensate. It is a completely automatic
operation and the pump will operate only
when water is present and will stop when the
water has been pumped away. Each pump
will remove up to 14 liters/hour (3.75 gph).
Water-cooled Condenser Coil
All Kompac series units are equipped with
coaxial/trombone “tube-in-tube” design
condenser coil. Water flows through the
inner tube while refrigerant flows in the
annulus between the inner and outer tubes.
Filter
All Kompac series units are equipped with
1/2” thick, washable, aluminum mesh air
filter located behind the front panel that can
To Next Page
Loading...
