Vers. 111422 23
(8) Torque charts
Tap to display the Torque-time and torque-angle charts for last screw. Refer to Torque
and Angle graphing for usage.
(9) Torque measurement unit
You can select a different unit from the GENERAL SETTINGS menu.
(10) Status bar
Shows the last screw result or error messages (ready, screw OK, screw NOK, errors).
(11) Torque target / bounds
Shows the target torque when in torque control mode, or the min/max torque bounds
when in angle control mode or timed tightening mode, for the current program.
(12) Torque value
Measured torque value applied to the last screw.
(13) Program description
Shows the description for the current program. You can enter a description for the
current program via Programs Menu > Other > DESCRIPTION.
To Next Page
Loading...