Vers. 111422 41
MULTI-STEP AND COMBINED PROGRAMS
To reverse the screwdriver at the beginning of the tightening, or after reaching the closing
torque, or to change the direction of tightening, refer to the corresponding options in the
REV & PRE-REV menu.
To combine multiple programs in a single tightening, you can configure a sequence with
the Program transition box set to “auto”.
The sequence will then transition between two or more programs automatically while the
operator continues to hold the screwdriver lever. The screwdriver will stop momentarily in-
between programs. Activate the LEVER ERROR setting for each program involved to raise
an error if the operator stops holding the lever during or in between the programs.
This allows to have multi-program tightening strategies.
To Next Page
Loading...