Vers. 111422 36
Refer to the GENERAL SETTINGS menu and PROGRAMS menu chapters for information
on how to configure the CBS880 accessory.
If at any time: no bits are lifted, or more than one bit is lifted, or if REMOTE PR/SEQ is set
to SWBX/CBS and an incorrect bit is lifted, the controller will remain locked.
Note: if you use less than 8 sockets with the CBS880 accessory, it is recommended to
physically disable the unused sockets by turning off the corresponding DIP switches inside
the CBS880 accessory, shown in the picture below. Refer to the CBS880 product manual for
more information.
To Next Page
Loading...