Vers. 111422 63
will be printed in the corresponding results string on the serial port and on the
corresponding Modbus field (see serial print and remote I/O chapters on this manual).
The scan barcode screen will appear again after the current program completes on when
a new program number is selected.
On PROG: on the main screen, the scan barcode screen will appear. Scanning a barcode
will load the program containing the matching barcode. If there is no program with a
matching barcode, the operator will be prompted to scan another barcode. The scan
barcode screen will appear again after the loaded program completes. You can configure
a unique barcode for each program via PROGRAM > OTHER > BARCODE.
On SEQ: on the main screen, the scan barcode screen will appear. Scanning a barcode
will load the sequence containing the matching barcode. If there is no sequence with a
matching barcode, the operator will be prompted to scan another barcode. The scan
barcode screen will appear again after the loaded sequence completes. You can
configure a barcode for each sequence via the BARCODE SEQ. setting on the
SEQUENCE SETTINGS menu. This option is will only appear if SEQUENCE mode is
active (SEQUENCE toggle > ON).
SN+Prog: This mode combines the “On Serial Number” and “On PROG” modes. First,
the “scan serial number barcode” screen will appear. Then, after the first scan, the “scan
PROG barcode” screen will appear. The program containing the barcode matching the
“PROG” scan (second scan) will be loaded, while the first barcode scanned (“serial
number”) will be printed with the screwdriving results.
Both “scan barcode” screens will reappear after the program completes.
SN+Seq: This mode combines the “On Serial Number” and “On SEQ” modes. First, the
“scan serial number barcode” screen will appear. Then, after the first scan, the “scan
SEQ barcode” screen will appear. The sequence containing the barcode matching the
“SEQ” scan (second scan) will be loaded, while the first barcode scanned (“serial
number”) will be printed with the screwdriving results.
Both “scan barcode” screens will reappear after the sequence completes.
(8) SWBX88/CBS880
Changes the working mode for the SWBX88 and CBS880 Kolver accessories:
OFF: disabled
ON PROG: the position selected on the accessory will load the program number
containing the matching SWBX88/CBS880 setting (Programs > Other >
SWBX88/CBS880).
ON SEQ: the position selected on the accessory will load the corresponding sequence.
This sequence letters are matched to the numbers alphabetically (A-1, B-2, …, H-8). This
option is will only appear if SEQUENCE mode is active (SEQUENCE toggle on the
Sequence Settings menu).
Also see: Connecting Kolver accessories SWBX88, CBS880
(9) LANGUAGE / UNIT / BRIGHTNESSS
LANGUAGE: choose the display language: English, Italian, French, German, Spanish,
Portuguese.
UNIT: choose the measurement units for torque: Nm, lbf.in, kgf.cm, ozf.in, cNm
To Next Page
Loading...