Vers. 111422 9
TOOL connector
To connect a KDS-NT (Patent pending) series screwdriver. Take care to respect the
alignment tabs on the connector. See Installation of KDS screwdriver section for
instructions on connecting the screwdriver.
CN1 ethernet connector RJ45
To connect using MODBUS TCP, or K-Expand from a PLC, PC, or server. Refer to the
REMOTE CONTROL INTERFACES chapter.
USB A
Plug in a FAT32 formatted flash drive to automatically save screwdriving results and
backup all settings. Refer to the Retrieving and storing the screwdriving results and USB
menu sections.
USB mini B
To connect using K-Expand software. Refer to the K-EXPAND software chapter.
CN2 male serial connector
To connect with a compatible barcode scanner, such as Kolver Barcode P/N 020050, serial
printers such as Kolver PRNTR1, or serial terminals (PC/PLCs).
CN3 female serial connector
To connect with Kolver accessories SWBX88/CBX880, serial printers such as Kolver
PRNTR1, or serial terminals (PC/PLCs).
CN4 female serial connector
Reserved for servicing the unit.
CN5 I/O connector
To connect with 24V I/O functionality such as PLCs, pedals/buttons, LEDS, etc. Refer to the
REMOTE CONTROL INTERFACES chapter.
To Next Page
Loading...