Technical details
4-3
NOISE EMISSION LEVELS
Two rating plates with details of the machine's noise level must be
mounted on the machine:
In compliance with EC directive 95/27/EEC:
1 plate for sound pressure level L
pA
= 76 dB/A
1 plate for sound power level L
WA
= 106 dB/A
No alterations may be made to the machine which could have an influence
on the noise emission levels.
VIBRATION LEVEL
When used for its intended purpose, levels of vibration for the earthworking
machine transmitted from the operator's seat are lower or equal to the
test vibrations for the relative machinery class in compliance with ISO
7096. The actual acceleration value of the upper limbs is less than 2.5
m/s
2
. The actual acceleration value for the body is less than 0.76 m/s
2
.
These values were determined using a representative machine and with
the help of the measurement procedures that are defined in the directives
ISO 2631/1 and ISO 5349.
LIMIT VALUES FOR SLOPES
Maximum slope angle for operating the machine
If operating the machine on a slope, its angle must not exceed 35° uphill,
downhill or sideways. If you angle the machine at more than 35° during
operation, the motor, transmission, hydraulic system or axles, will not be
supplied with sufficient oil and can be damaged.
A uphill 35°
B downhill 35°
C sideways 35°
To Next Page
Loading...
Need help?
General
