KGP-1
(Original Instructions)
2-14
P/N 810498 Rev C
© 2021 Konami Gaming Inc.
SECTION 2 - SET UP
Player Tracking Panel
The Slot Accounting System (SAS) components are mounted
on a removable panel installed on the Main Deck� Use the
following instructions to remove and install the bracket�
Removal
1� Open the Main Deck Door�
2�
3� Remove four #8-32 nuts holding the Player Tracking
Panel�
4� Remove Player Tracking Panel from Main Deck�
Installation
1� Install Player Tracking Panel onto Main Deck�
2� Secure with four #8-32 nuts�
3� Turn on machine power�
4� Close Main Deck Door�
Fiber Optic Interface
routed to the SAS Unit mounted in the machine� The SAS
output connector and attached wiring, the output of which is
connected to the CNB35 port on the Backplane board�
SERIAL
I/O
Green : Communication
Blink
Lit Off
Normal
Error Idling
Normal
Error
Idling
Normal
Error Idling
Red : Opto IN2 Monitor
Yellow : Terminal Serial Data
SERIAL
I/O
OUT1 OUT2 IN1 IN2
SERIAL I/O
FIBER OPTIC OUT 1
FIBER OPTIC OUT 2
FIBER OPTIC IN 2
FIBER OPTIC IN 1
AC 115V IN
AC115V IN
CABINET INSTALLATION
This section describes the procedure for installing the cabinet
• Opening and Closing Doors
• Changing Locks
Opening and Closing the Doors
This section addresses how you access and open the doors
on and in the cabinet�
Belly Door
1� To open, insert the key into the Key Cylinder and turn 90
degrees clockwise�
2� Pull down the Belly Door�
3� To close, push the Belly Door up�
4� Turn key 90 degrees counter-clockwise and remove from
the Key Cylinder
Main Deck
The Main Deck
1� To open, insert the key into the Key Cylinder and turn
90 degrees clockwise�
To Next Page
Loading...
Need help?
General
