42
7-1 Replacing the coin selector
How to replace the coin selector
•Before replacing the coin selector, be sure to turn OFF the main power
switch and unplug the power cord from the receptacle.
•When replacing parts, be sure to use parts of the correct specifications.
Never use parts other than the specified ones.
•Strictly refrain from disassembly and repair of parts which are not indicated
in this manual, as well as settings and remodelling.
1 Be sure to turn OFF the main power
switch and unplug the power cord
from the receptacle.
2 Open the maintenance door.
3 Release the levers that fix the coin
selector. See at right.
7 Maintenance
5
To fit the coin selector again
Fit the 2 projections of the coin
selector to their mating notches.
6 Lock the levers (in Step 3 above)
again, and close the maintenance
door.
4 Slide the coin selector to the right,
and take it out.
Maintenance door
Lever
Microswitch
Coin selector
Slide in this
direction.
Projections
Notch
To Next Page
Loading...
