54
4 Remove the wing bolts. Hold the
grip and gently draw out the
wooden board with the PCB unit
attached.
Wooden board
Grip
Wing bolts
PCB unit
DIP switch
7 Maintenance
MEMO
•Be careful not to force the cover up
too far. The wires connected may be
damaged inside.
•Factory-adjusted DIP switch settings:
·Bit Nos. 1 thru 8: Set at OFF
5
To fit the PCB unit again
Push the unit fully into position with enough care not to get the wires caught.
6 Fix the wooden board with the wing bolts and reconnect the connectors.
7 Secure the side door tightly with the screws.
To Next Page
Loading...
